Acquire - Alignment and Acquisition

You configure acquisition and align sensors on the Acquire page.

Scan settings are displayed in two sections: the top section, by default called Gocator 0, and the Sensor Properties section.

Settings such as the scan mode, X spacing intervals, and triggering, which must apply to all sensors in a multi-sensor system (that is, as a sensor group), are in the top section. For consistency, in single-sensor systems and with models such as Gocator 3x00 that don't support multi-sensor grouping, these settings are separated from the others in this section.

Note that the sensor system's maximum possible frame rate is displayed at the top of this section. This value changes depending on some of the settings in the Sensor Properties section (see below).